Vanner RE Series Manual de instalación descargar pdf (Pagina 19)

Installation and Start-up



2001 Phone: (614) 771-2718 RE-ACM

Vanner Inc. FAX: 614-771-4904 Owners/Installation Manual

4282 Reynolds Dr. www.vanner.com Rev 0.1a

Hilliard Ohio 43026 RE-ACM-Owners_Man_R01a.doc

INCORPORATED

INCORPORATEDINCORPORATED

INCORPORATED

Verify that the AC utility cables are still disconnected from the AC Utility. Insert AC utility cables through

the entry/exit port and into the AC wiring raceway. Connect L1, N, L2 and ground to the appropriate

terminals in the terminal strip and torque each of the AC terminal screws to 15 inch pounds. Re-torque

after 30 days.

Inverter AC Input Connection:

Connect 240 Volt Vrms Three wire Inverter Input L1, L2, N, and GND to

the Inverter AC Input on the RE-4500 using 12 gauge wire minimum (10 gauge recommended for best

performance).

Verify that the RE-4500 is off and that the AC utility cables are still disconnected from the AC Utility.

Insert Inverter AC Input cables through the entry/exit port and into the AC wiring raceway. Connect L1, N,

L2 and ground to the appropriate terminals in the terminal strip and torque each of the AC terminal

screws to 15 inch pounds. Re-torque after 30 days.

Inverter AC Output:

Connect 120/240 volt single phase load L1, L2, N, GND to AC output terminals

using 12 gauge wire minimum (10 gauge recommended for best performance). Please refer to the AC

Interconnection Figure

Verify that the RE-4500 is off and that the AC power is still disconnected from the AC Utility. Insert

Inverter AC Output cables through the entry/exit port and into the AC wiring raceway. Connect L1, N, L2

and ground to the appropriate terminals in the terminal strip and torque each of the AC terminal screws to

15 inch pounds. Re-torque after 30 days.

Chassis Ground (28):

Connect to compression fitting terminal using 12 gauge wire minimum (10 gauge

recommended for best performance).

Use the Chassis Ground compression fitting (28) to ground the chassis using 10 gauge wire. . Connect

the chassis ground wire to the compression fitting and torque the bolt to 75 inch pounds. Re-torque after

30 days.

5.3 DC Raceway Wiring Installation Procedure

This section covers the interconnection and wiring of the RE-ACM DC Raceway (shown below in Figure

5.3-1. The major connections that need to be made are the connections for the control cable back to the

RE-4500 (Vanner Part Number TBD), and the connections for the “

Start

” and “

Run

” contacts for the

generator.

F 9 Figure 5.3-1 ACM DC Raceway Connections

RIGHT

BACK

FRONT

LEFT

DC RACEWAY

GENERATOR

CONTROL

START

GND

RUN

+24V

Generator Control

Connector

Generator Control

Terminals

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios

Vanner RE Series Manual de instalación Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para Adaptadores E Inversores De Energía Vanner RE Series